Suzuki GSF650A - Handlebar Construction (GSX650 FK8); Specifications; Tightening Torque Specifications

6B-11 Steering / Handlebar:
Handlebar Construction (GSX650FK8)
B817H26206012
Specifications
Tightening Torque Specifications
B817H26207001
NOTE
The specified tightening torque is also described in the following.
“Handlebars Components (Page 6B-1)”
“Handlebar Construction (GSF650/S/A/SAK7) (Page 6B-2)”
“Steering Components (Page 6B-5)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque Specifications in Section
0B (Page 0B-24)”.
1. Handlebar switch (LH) : Apply bond.
“A”: Apply a small amount of the bond 1207B to inside of the handlebar switchbox.
“A”
1
I817H2620001-01
Fastening part
Tightening torque
Note
N⋅mkgf-mlbf-ft
Handlebar holder bolt 23 2.3 16.5 )(Page 6B-3)
Handlebar holder set nut
45 4.5 32.5
)(Page 6B-5) /
)(Page 6B-8)
Steering stem nut 45 N⋅m (4.5 kgf-m, 32.5 lb-ft) then turn back
1/2 – 1/4.
)(Page 6B-8)
Steering stem head nut 65 6.5 47.0 )(Page 6B-8)