1D-32 Engine Mechanical:
• Install the cam chain tension adjuster (3) and tighten
its mounting bolts.
Tightening torque
Cam chain tension adjuster mounting bolt (a): 10
N·m (1.0 kgf-m, 7.0 lbf-ft)
• Install the spring (4).
• Install the gasket (5) and cam chain tension adjuster
cap bolt (6).
NOTE
Click sound is heard when the cam chain
tension adjuster cap bolt is installed.
• Tighten the cam chain tension adjuster cap bolt (6) to
the specified torque.
Tightening torque
Cam chain tension adjuster cap bolt (b): 23 N·m (
2.3 kgf-m, 16.5 lbf-ft)
CAUTION
!
After installing the cam chain tension
adjuster, check to be sure that the adjuster
works properly by checking the slack of cam
chain.
• After installing the cam chain tension adjuster, rotate
the crankshaft (some turns), and recheck the
positions of the camshafts.
• Be sure to check and adjust the valve clearance.
Refer to “Valve Clearance Inspection and Adjustment
in Section 0B (Page 0B-6)”.
Right Crankshaft Cover
• Apply SUZUKI BOND lightly to the mating surfaces at
the parting line between the upper and lower
crankcases as shown.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
(a)
2
3
I717H1140093-01
5
4
(b)
6
I717H1140094-02
I717H1140216-02
I717H1140095-01
To Next Page
Loading...
