0B-5 Maintenance and Lubrication:
Cleaning
1) Remove the air cleaner element. Refer to “Air
Cleaner Element Removal and Installation in Section
1D (Page 1D-7)”.
2) Carefully use compressed air to clean the air cleaner
element.
CAUTION
!
Always apply compressed air to the inside of
the air cleaner element. If compressed air is
applied to the outside, dirt will be forced into
the pores of the air cleaner element,
restricting air flow through the air cleaner
element.
3) After cleaning the air cleaner element, reinstall the
removed parts.
4) Drain water from the air cleaner by removing the
drain plug.
5) Reinstall the drain plug.
Exhaust Pipe Bolt and Muffler Bolt Inspection
B817H20206003
Tighten exhaust pipe bolts, muffler bolt and nut
Initially at 1 000 km (600 miles, 2 months) and every
12 000 km (7 500 miles, 24 months) thereafter.
Check the exhaust pipe bolts, muffler bolts and nut to the
specified torque.
Tightening torque
Exhaust pipe bolt (a): 23 N·m (2.3 kgf-m, 16.5 lbf-ft)
Exhaust pipe mounting bolt (b): 23 N·m (2.3 kgf-m,
16.5 lbf-ft)
Muffler connecting bolt (c): 23 N·m (2.3 kgf-m, 16.5
lbf-ft)
Muffler mounting nut (d): 25 N·m (2.5 kgf-m, 18.0
lbf-ft)
Spark Plug Replacement
B817H20206004
Replace spark plug
Every 12 000 km (7 500 miles, 24 months)
Refer to “Ignition Coil / Plug Cap and Spark Plug
Removal and Installation in Section 1H (Page 1H-3)”.
Spark Plug Inspection and Cleaning
B817H20206005
Inspect spark plug
Every 6 000 km (4 000 miles, 12 months)
Heat Range
1) Remove the spark plugs. Refer to “Ignition Coil /
Plug Cap and Spark Plug Removal and Installation in
Section 1H (Page 1H-3)”.
2) Check spark plug heat range by observing electrode
color.
If it is white or glazed appearing, replace the spark
plug with colder type one.
Heat range
3) After finishing the spark plug inspection, reinstall the
removed parts.
I718H1020010-01
I718H1020011-01
Standard Cold type Hot type
NGK CR9E CR10E CR8E
DENSO U27ESR-N U31ESR-N U24ESR-N
(d)
(b)
(a)
(c)
I718H1020007-04
To Next Page
Loading...
