Front Suspension: 2B-7
Cylinder bolt
• Install the ring (1) to the cylinder.
NOTE
The cylinder ring should be installed onto the
cylinder with its oil passage notches “A”
facing downward.
• Install the rebound spring (2) to the cylinder (3).
• Apply fork oil to the cylinder ring.
: Fork Oil 99000–99044–10G (SUZUKI FORK
OIL G-10 or equivalent)
• Insert the cylinder (3) into the inner tube.
• Apply thread lock to the cylinder bolt and tighten it to
the specified torque with a 6-mm hexagon wrench and
special tools.
CAUTION
!
Use a new cylinder bolt gasket to prevent oil
leakage.
NOTE
Check the front fork for smoothness by
stroking it after installing the cylinder.
Special tool
(A): 09940–34520 (T handle)
(B): 09940–34531 (Attachment A)
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Front fork cylinder bolt: 30 N·m (3.0 kgf-m, 21.5
lbf-ft)
1
“A”
I717H1220026-01
2
3
I717H1220027-01
I718H1220012-03
(B)
(A)
I717H1220028-01
To Next Page
Loading...
