4E-25 ABS:
Use of SDS
NOTE
• Don’t disconnect couplers from ABS HU,
the battery cable from the battery, ABS HU
ground wire harness from the engine or
main fuse before confirming the
malfunction code (self-diagnostic trouble
code) stored in memory. Such
disconnection will erase the memorized
information in ABS HU memory.
• DTC stored in ABS HU memory can be
checked by the SDS.
1) Remove the right frame cover. Refer to “Exterior
Parts Removal and Installation (GSF650/S/A/SAK7)
in Section 9D (Page 9D-6)”.
2) Set up the SDS tool. (Refer to the SDS operation
manual for further details.)
Special tool
(A): 09904–41010 (SDS set)
(B): 99565–01010–010 (CD-ROM Ver.10)
3) Read the DTC (Diagnostic Trouble Code) and show
data when trouble (displaying data at the time of
DTC) according to instructions displayed on SDS.
NOTE
• Not only is SDS used for detecting
Diagnostic Trouble Codes but also for
reproducing and checking on screen the
failure condition as described by
customers using the trigger.
• How to use trigger. (Refer to the SDS
operation manual for further details.)
4) Close the SDS tool and turn the ignition switch OFF.
(A)
I718H1450047-01
(A)
(B)
I705H1110116-03
To Next Page
Loading...
