Suzuki GSF650A - Page 545

ABS: 4E-58
4 1) Measure the resistance between “B” (W) and ground at
the rear wheel speed sensor coupler.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Resistance (Ω)
Normal value (“B” – Ground)
∞ Ω (Infinity)
Is the resistance between “B” and ground OK?
Inspect the wire
harness. (Faulty W/Y
wire)
Replace the rear wheel
speed sensor.
5 1) Check for continuity between “2” (B/Y) on the ABS
control unit coupler and “C” (B/Y) on the rear wheel
speed sensor coupler.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
(B): 09900–25009 (Needle pointed probe set)
Tester knob indication
Continuity test ( )
Normal value (“2” – “C”)
Continuity ( )
Is there continuity between “2” and “C”?
Go to Step 6. Inspect the wire
harness. (Faulty B/Y
wire)
Step Action Yes No
Sensor side
“B”
(A)
I718H1450081-03
?
ABS control unit coupler (Harness end)
Harness side
“C”
10
18
12 13
24
16
89
24
25
21
3
(A)
(B)
I718H1450090-03