Manual Transmission: 5B-7
• With engaging each forks (5) end to the cam groove,
insert the fork shaft (6).
• Apply thread lock to the screws and tighten them to
the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Gearshift fork shaft retainer screw (a): 10 N·m (
1.0 kgf-m, 7.0 lbf-ft)
Gearshift cam retainer screw (b): 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
Driveshaft Assembly
• Install the bearing pin (1).
• Install the driveshaft assembly on the upper
crankcase.
NOTE
• Align the gearshift forks (2) with their
grooves (3).
• Align the C-ring with the groove of bearing
and the bearing pin with the indent on the
bearing.
• Turn the bearing to fit the bearing dowel pin in the
position “A”.
• Assemble the engine. Refer to “Engine Bottom Side
Disassembly in Section 1D (Page 1D-51)” and
“Engine Top Side Assembly in Section 1D (Page 1D-
26)”.
• Remount the engine assembly. Refer to “Engine
Assembly Installation in Section 1D (Page 1D-21)”.
5
6
I717H1520007-02
(a)
(b)
I717H1520031-01
1
I718H1520026-01
2
3
I717H1520009-03
“A”
I717H1520010-01
To Next Page
Loading...
