Suzuki GSF650A - Page 582

5B-16 Manual Transmission:
9) Remove the gearshift arm stopper (14).
Installation
Install the gearshift shaft and gearshift cam plate in the
reverse order of removal. Pay attention to the following
points:
CAUTION
!
The removed snap rings must be replaced
with new ones.
• Apply a small quantity of thread lock to the gearshift
arm stopper and tighten it to the specified torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Gearshift arm stopper (a): 19 N·m (1.9 kgf-m, 13.5
lbf-ft)
• Install the gearshift cam stopper (1), bolt (2), washer
(3) and return spring (4).
• Tighten the gearshift cam stopper bolt (2) to the
specified torque.
NOTE
Hook the return spring end “A” to the
stopper (1).
Tightening torque
Gearshift cam stopper bolt (b): 10 N·m (1.0 kgf-
m, 7.0 lbf-ft)
• Check the gearshift cam stopper moves smoothly.
• Locate the gearshift cam in the neutral position.
• Install the gearshift cam stopper plate (5).
NOTE
Align the gearshift cam pin “B” with the
gearshift cam stopper plate hole “C”.
14
I718H1520051-01
(a)
I718H1520052-01
1
2
3
4
I718H1520003-03
1
“A”
(b)
2
I717H1520022-01
5
“B”
“C”
I718H1520054-01