Suzuki GSF650A - Page 618

6B-7 Steering / Handlebar:
4) Remove the cable guides (2).
5) Dismount the handlebars and steering upper
bracket. Refer to “Ignition Switch Removal and
Installation in Section 1H (Page 1H-7)”.
NOTE
If necessary, remove the ignition switch from
the upper bracket. Refer to “Ignition Switch
Removal and Installation in Section 1H
(Page 1H-7)”.
6) Remove the steering stem nut using the special tool.
NOTE
When loosening the stem nuts, hold the
steering stem lower bracket to prevent it from
falling.
Special tool
(A): 09940–14911 (Steering stem nut
wrench)
7) Remove the steering stem lower bracket.
8) Remove the dust seal (3) and steering stem upper
bearing (4).
Installation
Install the steering in the reverse order of removal.
Pay attention to the following points:
Bearing
• Apply SUZUKI SUPER GREASE to the bearings,
races and dust seals before remounting the steering
stem.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
2
I717H1620019-01
(A)
I717H1620023-02
3
4
I717H1620024-02
I717H1620025-01