Suzuki GSF650A - Page 636

9A-9 Wiring Systems:
[A]
[B]
9
11
13 12
14
“B”
15
16
“a”
8
5
6
7
1
“A”
3
4
(a)
2
10
I717H1910906-01
1. Clamp
: Clamp the speed sensor lead wire and HO2 sensor lead wire.
12. Turn signal lead wire (RH)
2. Side-stand switch 13. Turn signal lead wire (LH)
3. HO2 sensor coupler 14. Clamp
: Clamp the regulator/rectifier lead wire and generator lead wire.
4. ABS control unit/HU bracket (GSF650A/SA only)
: Do not contact the ABS unit wiring harness with the bracket.
15. Clamp
: Clamp the speed sensor lead wire, HO2 sensor lead wire and side-
stand switch lead wire.
5. Frame 16. Clamp
: Clamp the lead wire inside of clutch hose.
6. Wiring harness (GSF650/A) “A”: Pass the regulator/rectifier lead wire behind hose.
7. Wiring harness (GSF650S/SA) “B”: Set the generator lead wire between starter motor and sprocket inner
cover.
8. ICES CANADA label (E-28 only) : 14 N⋅m (1.4 kgf-m, 10.0 lb-ft)
9. Clamp
: Clamp the lead wire at the white marking.
“a”: 20 ± 5 mm (0.8 ± 0.2 in)
10. Clamp
: Clamp the speed meter lead wire and turn signal lead wires.
[A]: For GSF650/GSF650A
11. Wiring harness [B]: For GSF650S/GSF650SA