Suzuki GSX1300R - Page 259

Engine Mechanical: 1D-38
• Install the oil pipe (4) and tighten oil pipe bolts to the
specified torque.
NOTE
• Install the washer (5) between each bolt
and oil pipe.
• The exhaust side oil pipe bolt (6) is longer
than the intake side one (7).
Tightening torque
Oil pipe bolt (Camshaft housing): 10 N·m (1.0 kgf-
m, 7.0 lb-ft)
• Install the cam chain guide No. 2 (8).
Tightening torque
Cam chain guide No. 2 bolt: 10 N·m (1.0 kgf-m,
7.0 lb-ft)
• Remove the clamps.
Cam Chain Tension Adjuster
• Holding the cam chain tension adjuster as shown in
the figure, compress the plunger by turning the
adjuster body until the outer circlip “A” reaches the
groove “B”.
• Hook the outer circlip “A” into the groove “B”, then turn
the plunger head clockwise more than 90° to make a
little play at the inner thread mechanism.
IN.
EX.
9
9
10
10
5 (1)
5 (1)
6 (2)
6 (2)
7
7
8
8
3
3
4
4
11
11
12
12
I823H1140079-03
4
I823H1140080-01
5
7
5
6
I823H1140081-01
8
I823H1140082-01
“A”
“B”
I823H1140355-01