Suzuki GSX1300R - Page 270

1D-49 Engine Mechanical:
Assembly
Assembly is in the reverse order of disassembly. Pay
attention to the following points:
• Tighten the cam chain tension adjuster service cap (1)
and oil gallery plug (2) to the specified torque.
CAUTION
!
Replace the gaskets with new ones.
Tightening torque
Cam chain tension adjuster service cap (a): 23
N·m (2.3 kgf-m, 16.5 lb-ft)
Oil gallery plug (Cylinder head) (b): 10 N·m (1.0
kgf-m, 7.0 lb-ft)
• Apply bond to the thread part of the water bypass
union (3) and tighten it to the specified torque.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
Tightening torque
Water bypass union (c): 14 N·m (1.4 kgf-m, 10.0
lb-ft)
• After aligning the boss “A” on the cylinder head with
the slit on the intake pipe, install the intake pipes.
(a)
1
(b)
2
I823H1140119-02
(c)
3
I823H1140296-02
“A”
I823H1140120-01