Suzuki GSX1300R - Page 271

Engine Mechanical: 1D-50
• Set the clamp screws as shown in the figure.
• Install the thermostat.
NOTE
The air bleeder hole “F” of the thermostat
faces upside.
• Tighten the thermostat cover bolts (4) to the specified
torque.
Tightening torque
Thermostat cover bolt (d): 10 N·m (1.0 kgf-m, 7.0
lb-ft)
• Tighten the ECT sensor (5) to the specified torque.
Tightening torque
Engine coolant temperature sensor (e): 18 N·m (
1.8 kgf-m, 13.0 lb-ft)
CAUTION
!
• Take special care when handling the
temperature sensor. It may cause damage
if it gets a sharp impact.
• Replace a gasket with a new one.
“a”
“a”
“a”
“a”
“B”
“C”
“D” “E”
I823H1140121-03
“B”: Upper “C”: Lower “D”: Left “E”: Right “a”: 45°
“F”
(d)
4
I823H1140122-04
(e)
5
I823H1140123-03