Suzuki GSX1300R - Page 424

1K-5 Exhaust System:
13) Remove the exhaust pipe gaskets (10).
14) Remove the HO2 sensor (11) from the exhaust pipe.
CAUTION
!
• Be careful not to expose the HO2 sensor to
an excessive shock.
• Be careful not to twist or damage the HO2
sensor lead wire.
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Tighten the HO2 sensor (1) to the specified torque.
Tightening torque
HO2 sensor (a): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
CAUTION
!
• Be careful not to expose the HO2 sensor to
an excessive shock.
• Do not use an impact wrench when
installing the HO2 sensor.
• Be careful not to twist or damage the HO2
sensor lead wires.
• Do not apply oil or other materials to the
sensor air holes.
• Install the exhaust pipe gaskets (2).
CAUTION
!
Replace the gaskets with new ones.
10
I815H11B0013-01
11
I815H11B0014-01
(a)
1
I815H11B0015-01
2
I815H11B0016-01