Suzuki GSX1300R - Page 541

Manual Transmission: 5B-5
• Install the gearshift cam along with the bearing.
NOTE
The stamped mark side of the gearshift cam
bearing faces outside.
• Install the gearshift forks and their shafts in position.
• Install the bearing retainer (4).
NOTE
Apply a small quantity of thread lock to the
bearing retainer screws and tighten them to
the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Bearing retainer screw: 8 N·m (0.8 kgf-m, 6.0 lb-ft)
Driveshaft / Countershaft Assembly
• Install the bearing pins (1), (2) and C-ring (3) on the
upper crankcase.
NOTE
Before installing the transmission assembly,
use a nonflammable cleaning solvent to wipe
off oily or greasy matter from the crankcase
mating surfaces and outside of the oil seal
fitting surfaces.
“A”: For 3rd/ 4th drive gears
“B”: For 6th driven gear
“C”: For 5th driven gear
I823H1520010-01
“A”
“B”
“C”
I823H1520011-02
“A”
“B”
“C”
I823H1520012-02
4
I823H1520013-01
1
2
3
I815H1520003-01