Wiring Systems: 9A-6
8. Clamp
: Bind the handlebar switch lead wires (LH/RH), ignition switch lead wire and
immobilizer antenna lead wire (E-02, 19, 24) with the clamp.
22. IAP sensor
9. Guide
: Pass the handlebar switch lead wires (LH/RH) and immobilizer antenna lead wire
(E-02, 19, 24) into the guide.
23. Combination meter coupler
10. Clamp
: Bind the IAP sensor lead wire, secondary fuel injector lead wire and TP sensor lead
wire with the clamp.
24. EVAP purge control solenoid valve (E-33 only)
11. Clamp
: Bind the wiring harness No. 2 with the clamp.
“A”: The coupler of #1 ignition coil/plug cap faces left side.
12. Wiring harness “B”: Do not make a wire slacked at part [B].
13. Starter motor lead wire [A]: Backside of the headlight
14. Fixed clamp
To Next Page
Loading...
