Suzuki GSX1300R - Page 608

9A-7 Wiring Systems:
9
[A]
6
5
4
“a”
1
2
3
11
7
8
12
13
10
[B]
14
15
“c” “c”
17
16
“b”
“A”
16
I815H1910908-01
1. Clamp
: Bind the wiring harness, starter motor lead wire, generator lead wire, gear
position switch lead wire and HO2 sensor lead wire with the clamp.
13. Seat rail
2. Clamp
: Bind the wiring harness, speed sensor lead wire and side-stand lead wire
with the clamp.
14. Oil pressure switch
3. Clamp
: Bind the starter motor lead wire, generator lead wire, gear position switch
lead wire and HO2 sensor lead wire with the clamp.
15. HO2 sensor
4. Clamp
: Bind the battery (+) lead wire with the clamp.
16. Ignition switch lead wire
: Pass the ignition switch lead wire on the outside of other lead
wires.
5. Clamp
: Bind the wiring harness with the clamp.
17. Gray taping
: Fasten the clamp on the gray taping. The width of the gray
taping on both the right and left of the clamp be at least 1 mm.
6. Clamp
: Bind the license plate light lead wire with the clamp. Cut off the excess end of
the clamp and set the locked part facing inside.
“A”: The ignition switch lead wire should not be hidden by other lead
wires when viewed within the range “b”.
7. Clamp
: Bind the wiring harness and handlebar switch lead wire (RH) with the clamp.
“a”: 5 – 10 mm (0.2 – 0.4 in)
8. Clamp
: Bind the handlebar switch lead wires (LH/RH), ignition switch lead wire and
immobilizer antenna lead wire (E-02, 19, 24) with the clamp.
“b”: 90°
9. Clamp
: Bind the rear turn signal light lead wire with the clamp.
“c”: 1 mm (0.039 in) and more
10. Clamp
: Bind the license plate light lead wire with the clamp.
[A]: Inside of the rear frame cover
11. IAT sensor [B]: Inside of the rear fender
12. Wiring harness