Suzuki GSX1300R - Page 650

9D-18 Exterior Parts:
Body Cowling
Removal
1) Remove the side cowlings. (LH & RH)
2) Remove the upper panels. (LH & RH)
3) Remove the rear view mirrors. (LH & RH)
4) Disconnect the lead wire coupler (1).
5) Remove the screws.
6) Remove the body cowling (2) forward.
Installation
Install the body cowling in the reverse order of removal.
Pay attention to the following points:
• Push in the hooked points on the body cowling to the
lug holes on the cowling brace.
• Adjust the headlight beam if necessary. Refer to
“Headlight Beam Adjustment in Section 9B (Page 9B-
3)”.
Intake Pipe
Removal
1) Remove the body cowling.
2) Remove the relay/fuse box bracket (1). (LH only)
3) Remove the intake pipes (2). (LH & RH)
Installation
Install the intake pipes in the reverse order of removal.
I823H1940027-01
1
I823H1940028-01
2
I815H1940018-02
I823H1940029-01
1
2
I823H1940030-01
2
I823H1940031-02