9-6 GEARSHIFTING
• Align the pin groove A with the pin B when installing the
stopper plate 7.
• Apply a small quantity of THREAD LOCK to the gearshift cam
driven gear pin 8 and tighten it to the specified torque.
99000-32050: THREAD LOCK “1342” or equivalent
Gearshift cam driven gear pin:
24 N·m (2.4 kgf-m, 17.5 lbf-ft)
• Fit the springs 9, pins 0, pawls A and gearshift roller B to
the gearshift cam driven gear C.
NOTE:
Wider side C of pawl should be positioned outside.
• With the pawls held in pushed position, install the pawl lifter
D.
To Next Page
Loading...
