FRONT FORK AND STEERING 18-27
• Align the matching mark C on the handlebars with the match-
ing surface clutch lever holder.
• Tighten the upper bolt D first temporarily to provide clearance
on the lower side and then tighten both the bolts 1.
• Install the engine stop switch 2 and clamps 3.
• Install the front number plate and handlebar pad.
INSPECTION AFTER INSTALLATION
• Front fork (2-36)
• Steering (2-37)
• Wiring harness, cable and hose routing
(20-18, -21, -22, -27, -28, -30)
• Handlebars set-up (20-32)
To Next Page
Loading...
