18-26 FRONT FORK AND STEERING
• Align the matching mark F on the handlebars with the match-
ing surface master cylinder.
• Tighten the master cylinder holder lower bolt G first tempo-
rarily to provide clearance on the upper side and then tighten
both the master cylinder holder bolts C to the specified
torque. (20-28)
Master cylinder holder bolt :
(Lower): 12 N·m (1.2 kgf-m, 8.5 lbf-ft)
(Upper): 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
HANDLEBARS
• Apply handle grip bond A to the left handlebar end and inside
of the left grip.
• Align the “ ” mark on the left grip with the matching mark B
on the left handlebar end.
To Next Page
Loading...
