Suzuki RM-Z250 - Page 88

5-4 ENGINE REMOVAL AND INSTALLATION
• Disconnect the GP switch coupler M.
• Remove the GP switch lead wire from the clamp N.
• Disconnect the magneto lead wire coupler O.
• Remove the clamps P.
• Remove the clutch cable bracket bolt Q and disconnect the
clutch cable R.
NOTE:
Loosen the clutch cable adjuster when disconnecting.
• Remove the throttle body S. (13-8, -9)
• Remove the ignition coil/plug cap T. (2-7)
• Remove the cotter pin U, washer V and clip W.