5-6 ENGINE REMOVAL AND INSTALLATION
INSTALLATION
Install the engine in the reverse order of removal. Pay attention to the following points:
• Fit the swingarm in its position and hold it with the swingarm pivot shaft.
• Mount the engine on the frame.
• Tighten the engine mounting bolts, nuts and swingarm pivot shaft nut to the specified torque.
NOTE:
After the engine has been installed and run, make sure to retighten the fasteners as they are subject to
becoming loose.
The engine mounting nut is the self-lock type and cannot be used repeatedly. If the self-lock
effect is lose, replace it with a new one.
a Shim ITEM N·m kgf-m lbf-ft
A 45 4.5 32.5
BC 66 6.6 47.5
D 70 7.0 50.5
EF 40 4.0 29.0
LH
RH
To Next Page
Loading...
