Suzuki RM-Z250 - Page 92

5-8 ENGINE REMOVAL AND INSTALLATION
• Install the return spring 7, brake pedal 8 and master cylinder
rod pin 9.
• Apply grease to the brake pedal pivot bolt 0.
 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent
• Tighten the brake pedal pivot bolt 0 to the specified torque.
 Brake pedal pivot bolt: 29 N·m (2.9 kgf-m, 21.0 lbf-ft)
• Install the clip A, washer B and cotter pin C.

• Install the kick starter lever D in the correct position.
(8-7, -8)
• Tighten the kick starter lever bolt E to the specified torque.
 Kick starter lever bolt: 29 N·m (2.9 kgf-m, 21.0 lbf-ft)
• Install the ignition coil/plug cap F securely. (2-8)
NOTE:
The coupler of ignition coil/plug cap faces backward.
b 90° – 110°
• Install the ignition coil retainer. (2-8)
Replace the cotter pin C with a new one.