2. Make sure that suitable Connection type is chosen. The default connection type is Internet,
however when the instrument is connected to the PC by the USB cable, connection type is
automatically changed to USB.
3. Choose the instrument in the station list.
4. Click Station configuration button.
Note: SV 200A provides AutoStart feature. If the instrument is idle for 60 s the
measurement is automatically started. The AutoStart function is inactive in the case: USB
is connected, or logging is switched off.
To start the measurement, perform next steps:
1. Make sure that the instrument is turned on.
2. Open Remote Communication Center.
3. Make sure appropriate Connection type is selected. If you wish to communicate with the
instrument via the 3G, WLAN or LAN connection, select Internet. If you wish to communicate
with the instrument via the USB cable, select USB.
4. Select the station in the Station list box.
5. Check the state of the instrument by clicking Check instrument(s) status. When the instrument
status is known, the Start measurement button becomes enabled.
6. Click the Start measurement button.
To Next Page
Loading...
Need help?
General
