To Next Page

To Previous Page

139

SV 200A User Manual

<result1> - PEAK result, depending on the value of BufferP[2] (cf. Table B.1.11)

<result2> - MAX result, depending on the value of BufferP[2] (cf. Table B.1.11)

<result3> - MIN result, depending on the value of BufferP[2] (cf. Table B.1.11)

<result4> - RMS result, depending on the value of BufferP[2] (cf. Table B.1.11)

(3) results of the measurement from the third profile if the corresponding LOGGER position was

active (BufferP [3] in Table B.1.11); up to four words are written:

<result1> - PEAK result, depending on the value of BufferP[3] (cf. Table B.1.11)

<result2> - MAX result, depending on the value of BufferP[3] (cf. Table B.1.11)

<result3> - MIN result, depending on the value of BufferP[3] (cf. Table B.1.11)

<result4> - RMS result, depending on the value of BufferP[3] (cf. Table B.1.11)

(4) results of 1/1 OCTAVE analysis if 1/1 OCTAVE analysis was selected as the measurement

function and the LOGGER was active (SpectrumBuff in Table B.1.5); the sequence of words is

written:

where:

flags = 1- overload detected, 0 - the overload not detected

Octave[i] - result of 1/1 OCTAVE analysis (*10 dB); i = 1÷NOct+NOctTot (1÷13)

(5) results of 1/3 OCTAVE analysis if 1/3 OCTAVE analysis was selected as the measurement

function and LOGGER was active (SpectrumBuff in Table B.1.5); the sequence of words is

written:

where:

flags = 1- overload detected, 0 - the overload not detected

Terave[i] - result of 1/3 OCTAVE analysis (*10 dB); i = 1÷NT (1÷34)

B.2.2 Record with the state of the markers

The record with the state of the markers consists of one word:

<0x8nnn>

in which 12 bits nnn denote the state of the markers:

b11 = state of #12 marker

b10 = state of #11 marker

...

b1 = state of #2 marker

b0 = state of #1 marker

B.2.3 Record with the breaks in the results registration

The record with the breaks in the results registration consists of four words:

<0xB0ii> <0xB1jj> <0xB2kk> <0xB3nn>

in which ii, jj, kk, nn bytes denote 4-bytes counter of left or skipped records: nnkkjjii (ii is the least

significant byte, nn – the most significant byte).

Svantek SV 200A User Manual

Questions and Answers: