EasyManuals Logo

Svantek SV 200A User Manual

Svantek SV 200A
198 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
85
SV 200A User Manual
3. view system log information (Show log button),
4. terminate the Live view session (Terminate button),
5. enable the SV 200A actuator and perform the instrument’s check (Enable Actuator button).
After enabling the actuator, the instrument starts measuring of the signal, generated by the actuator at
the level of 94 dB. If Read step is equal to 1s then it is possible to observe the measured actuator level.
9.7 CHANGING THE WORKING DIRECTORY
Working directory is a folder on the SD-card in which all the measurement files are stored.
Changing the working directory can be done with the SVAN Files feature of the SvanPC++ software
either via SV 200 Instrument wizard or via Remote Communication Center.
1. Make sure a measurement is not in progress.
2. Open the SVAN Files window and navigate to the desired directory using the left panel. The left
panel displays contents of the instrument’s memory. Create a new directory if necessary.
SVAN Files button
SVAN Files button

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Svantek SV 200A and is the answer not in the manual?

Svantek SV 200A Specifications

General IconGeneral
BrandSvantek
ModelSV 200A
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals