Important Instructions
Read the following instructions thoroughly before servicing or maintaining your
printer.
•
Place the printer on a solid and even base so that it cannot fall.
•
Always power off the printer and disconnect the power cord from the mains
before doing any servicing or maintenance work.
•
Be careful when handling parts with sharp metal edges.
•
Be careful of possible hot print head, if printing had just been performed.
•
Avoid touching the electronic components unless you have taken
anti-electrostatic discharge measures.
• During servicing, pay special attention to how the printer parts were
originally mounted.
•
Unless stated otherwise, the re-assembly process is the reverse of the
disassembly process.
•
After servicing any printer parts or assemblies, which are supplied with
critical voltage and therefore connected to frame ground, a
test/examination of the grounding wire has to be accomplished in
accordance with the national safety regulations.
To Next Page
Loading...
