Mask testing setups Start or reset a mask test
Start or reset a mask test
From the Mask menu, select Pass/Fail Results.
Overview
Use these controls to start a test or reset the test to the starting point.
To use
Click th
e On/Off control to start the test.
Click the Reset control to reset the test to the beginning.
Behavior
When t
he test starts, it uses the parameters in the Pass/Fail Test Setup control window. When the test is
reset, the Total Hits, Failed Wfms, Hits per segment, and Waveform Tested fields are reset to zero.
What
do you want to do next?
Learn about test summary. (see page 229)
Learn about hits per segment. (see page 231)
Learn about the Mask Test Controls window. (see page 886)
Learn about test results. (see page 228)
S
et the user mask controls
F
rom the Mask menu, se l ect Mask Setup; then open the Masks tab and click the User Mask button.
232 DSA/DPO70000D, MSO/DPO/DSA70000C, DPO7000C, and MSO/DPO5000 Series
To Next Page
Loading...
