SPG600 & SPG300 Sync Pulse Generators Service Manual 6-5
Removal and Installation Procedures
This subsection contains procedures for removal and installation of almost all
mechanical and electrical modules. Any electrical or mechanical module,
assembly, or part listed in Section 10 of this manual is a module.
Preparation
This subsection contains the following items:
Preparatory information that you need to properly perform the procedures that
follow.
List of tools required to remove and disassemble all modules.
Four module locator diagrams for finding the SPG600 external modules (see
Figure 6-2), SPG600 internal modules (see Figure 6-3), SPG300 external
modules (see Figure 6-4), and SPG300 internal modules (see Figure 6-5), in
the sync pulse generators.
Procedures for removal and reinstallation of the electrical and mechanical
modules.
A disassembly procedure for removal of all the major modules from the sync
pulse generator at one time and for reassembly of those modules into the sync
pulse generator. Such a complete disassembly is normally only done when
completely cleaning the sync pulse generator (instructions for doing the actual
cleaning are found under Inspection and Cleaning at the beginning of this
section).
Module disassembly procedures.
WARNING. Before performing this or any other procedure in this manual, read the
General Safety Summary and Service Safety Summary found at the beginning of
this manual. Also, to prevent possible injury to service personnel or damage to the
sync pulse generator’s components, read Installation in Section 2, and Preparation
on page 6-2.
WARNING. Before performing any procedure in this subsection, disconnect the
power cord from the line voltage source. Failure to do so could cause serious
injury or death.
To Next Page
Loading...
Need help?
General
