Removal and Installation Procedures
6-6 SPG600 & SPG300 Sync Pulse Generators Service Manual
List of Module
Section 10 lists all modules.
General Instructions
Read these general instructions before removing a module.
First read over the Summary of Procedures that follows to understand how the
procedures are grouped. Then read Equipment Required for a list of the tools
needed to remove and install modules in the sync pulse generator.
If you are removing a module for service, begin by performing the Access
Procedure (page 6-12). By following the instructions in that procedure, you
remove the module to be serviced while removing the minimum number of
additional modules.
Summary of Procedures
The procedures are described in the order in which they appear in this section. In
addition, you can look up any procedure for removal and reinstallation of any
module in the Table of Contents of this manual.
The Access Procedure on page 6-12 first directs you to the procedure(s) (if
any) that are required to access the module to be serviced, then it directs you
to the procedure to remove that module.
Table 6-1: Summary of procedures
Procedure Module Page
SPG600
Procedures for SPG600
External Modules
Top Cover
Front-panel assembly
RFI filter
6-13
Procedures for SPG600
Internal Modules
A30 Analog board (Option 02 only)
A40 SDI board (Option 03 only)
A10 Main board
Power supply module
6-17
SPG300
Procedures for SPG300
External Modules
Top Cover
Front-panel assembly
RFI filter
GPI connector
6-23
Procedures for SPG300
Internal Modules
A60 Analog board
A50 Main board
Power supply module
6-27
To Next Page
Loading...
Need help?
General
