SPG600 & SPG300 Sync Pulse Generators Service Manual 2-1
Installation
This section contains the following topics:
Supplying operating power
Operating environment
Applying and interrupting power
Repackaging instructions
Supplying Operating Power
NOTE. Read all information and heed all warnings in this subsection before
connecting the sync pulse generator to a power source.
WARNING. AC POWER SOURCE AND CONNECTION. The sync pulse generator
operates from a single-phase power source. It has a three-wire power cord and
two-pole, three-terminal grounding type plug. The voltage to ground (earth) from
either pole of the power source must not exceed the maximum rated operating
voltage, 250 volts.
Before making connection to power source, be sure the sync pulse generator has a
suitable two-pole, three-terminal grounding-type plug.
GROUNDING. This instrument is safety Class 1 equipment (IEC designation). All
accessible conductive parts are directly connected through the grounding
conductor of the power cord to the grounded (earthing) contact of the power plug.
To Next Page
Loading...
