Tektronix SPG600 Service Manual

Performance Verification
SPG600 & SPG300 Sync Pulse Generators Service Manual 4-13
3. Recall the Factory Default preset as follows:
a. Press the SYSTEM button to display the System menu.
b. Press the ENTER button to display the Preset submenu.
c. Press the left (
W) or right (X) arrow button to select Factory Default.
d. Press the ENTER button to recall the factory default settings.
4. Select the 75% Color Bars signal as follows:
a. Press the VIDEO button to display the Video menu.
b. Press the up (
S) or down (T) arrow button to select TEST SIGNAL
(SDI).
c. Press the ENTER button.
d. Press the left (
W) or right (X) arrow button to select 75% Color Bars.
5. Turn on the logo overlay as follows:
a. Press the CANCEL button to return the Video menu.
b. Press the up (
S) or down (T) arrow button to select OVERLAY.
c. Press the left (
W) or right (X) arrow button to select SDI (STD).
d. Press the ENTER button to display the Overlay submenu.
e. Press the left (
W) or right (X) arrow button to select Logo.
f. Press the ENTER button to display the Logo submenu.
g. Press the left (
W) or right (X) arrow button to select a logo.
6. Turn on the embedded audio for Group 1 as follows:
a. Press the AUDIO button to display the Audio menu.
b. Press the up (
S) or down (T) arrow button to select EMBEDDED
(STD/TEST).
c. Press the left (
W) or right (X) arrow button to select Group 1.
d. Press the ENTER button to display the Embedded submenu.
e. Press the left (
W) or right (X) arrow button to select Enable.
f. Press the ENTER button.
7. Press the Measure button on the video measurement set to open the Measure
mode display.

Tektronix SPG600 Specifications

General

Brand	Tektronix
Model	SPG600
Category	Pulse Generator
Language	English