CONFIGURATION FILES
CHAPTER 5
63
ECOTEL 3G 16.1. Revised: 1 March 2011.
Example: The following example is for an ECOTEL with FXS extension.
Example: The following example is for an ECOTEL with FXO extension.
ANA (continued)
<audio-law>
1 = a-law (default)
2 = μ-law
Analog FXO ports only:
<t-dial>
For outgoing calls only: duration (in ms) of dial state (default 500)
<t-alert>
For outgoing calls only: time (in ms) between last recognized alert tone
and transition to connect (default 10500)
<t-connect>
For outgoing calls only: time (in ms) between dial state and connect state
(default 10000)
<polarity reversal >
Used for setting polarity reversal (incoming calls) and ground start (out-
going calls):
0 = polarity reversal OFF (default)
2 = "polarity reversal ON
<t-reversal>
For incoming calls only: time (in ms) before detection of polarity reversal
cancelation (default 1000 ms)
DTMF[<sec>,/<dir>/
<file>]
Keyword to configure the DTMF controller. For a description of the format,
please see Chapter 12.2 on page 205 .
Subscriber00 = TRANSPARENT ROUTER ANA[0049,16,800,250,1500,80,12800,1,1]
Subscriber01 = TRANSPARENT ROUTER ANA[0049,16,800,250,1500,80,12800,1,1]
Subscriber02 = TRANSPARENT ROUTER ANA[0049,16,800,250,1500,80,12800,1,1]
Subscriber03 = TRANSPARENT ROUTER ANA[0049,16,800,250,1500,80,12800,1,1]
Subscriber04 = TRANSPARENT ROUTER UMTS[0000,00000,+495555555,1,1,1,SIM4] ALARM
Subscriber05 = TRANSPARENT ROUTER UMTS[0000,00000,+495555555,1,1,1,SIM4] ALARM
Subscriber06 = TRANSPARENT ROUTER UMTS[0000,00000,+495555555,1,1,1,SIM4] ALARM
Subscriber07 = TRANSPARENT ROUTER UMTS[0000,00000,+495555555,1,1,1,SIM4] ALARM
Subscriber08 = TRANSPARENT ROUTER SWITCH CHMAX[8] ALARM
Subscriber09 = TRANSPARENT ROUTER CHMAX[4] DTMF[30,/boot/DTMF.711]
Subscriber00 = TRANSPARENT ROUTER ANA[971,16,800,250,1500,80,12800,2,1,500,10500,10000,0,3000]
Subscriber01 = TRANSPARENT ROUTER ANA[971,16,800,250,1500,80,12800,2,1,500,10500,10000,0,3000]
Subscriber02 = TRANSPARENT ROUTER ANA[971,16,800,250,1500,80,12800,2,1,500,10500,10000,0,3000]
Subscriber03 = TRANSPARENT ROUTER ANA[971,16,800,250,1500,80,12800,2,1,500,10500,10000,0,3000]
Table 5.15 pabx.cfg: Subscriber Parameters (continued)
Subscriber<port>=<list>
To Next Page
Loading...
