EasyManua.ls Logo

TELES ECOTEL - Page 95

Default Icon
247 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SYSTEM MAINTENANCE AND SOFTWARE UPDATE
CHAPTER 7
95
ECOTEL 3G 16.1. Revised: 1 March 2011.
Remote Control: Date
& Time changed
Date and/or time were changed via remote administration.
Time Switch Operation
The configuration change was made by the timer.
Remote Administration
Remote Control from
<peer>, <Remote-
Code>, <service>, 0
Remote administration access from number or IP address.
Remote Control: OK
Successful remote administration access.
[993]Remote Control:
wrong password
X Remote administration access was denied because of a wrong pass-
word.
[994]Remote Control:
wrong number
X Remote administration access was denied because the call originat-
ed from an unauthorized number (
RemoteOrigination).
Remote Control
Terminated <start
time>,<end time>,
<num>, <RemoteCode>,
<service>,
0
Remote administration session from <num> ended. Session length
is indicated by start time and end time.
Errors Reported by the Status Program
[<port><i>] ERR:
Problem at Port <num>
X A Layer 1 or Layer 2 error occurred on <num>.
<i> indicates error type:
A Layer 1 error
; Layer 2 error
0 Layer 1&2 operational.
4 RSSI (for mobile only)
If the error persists, a differentiation is possible through 'status of
the ports'.
If this message appears, status inquiry connections via remote ad-
ministration are accepted and NMS downloads the
protocol.log file.
NOTE: If the RSSI falls below the value configured in the
pabx.cfg, the port will shut down automatically.
Attention: No Call-
back-Call <num> Ar-
rived
Callback with DTMF: the Callback Provider <num> did not call back
within approx. 20 sec.
Direct Line Access with DTMF: the call was accepted but disconnect-
ed again within x sec. (as defined by
MapCallBack-
WaitDisc
).
Table 7.1 Event Log Messages (continued)
Message NMS Definition

Table of Contents

Related product manuals