SYSTEM MAINTENANCE AND SOFTWARE UPDATE
CHAPTER 7
96
ECOTEL 3G 16.1. Revised: 1 March 2011.
The following status and error messages appear in the protocol.log file when ALARM appears in the VoIP
port’s subscriber line:
Write error
Access to the disk drive on which the data is to be stored was not
possible because it is set for read-only, full or because of faulty hard-
ware or software.
[995] Msg-Memory >
75%
X This message appears when message memory is over 75% full.
If this message appears, status inquiry connections via remote ad-
ministration are accepted and NMS downloads the
protocol.log file.
Table 7.2 Protocol Log Status and Error Messages
Message Definition
System Configuration (a)
config: <num> duplicate
profile
Specified line in pabx.cfg or route.cfg contains duplicate
profile.
config: <num> invalid
Specified line in pabx.cfg or route.cfg is invalid.
config: evaluation errcode
<num>
Internal error.
Port-Specific Entries
[<port>]Unblock Port
The <port> has been unblocked. This can occur via remote access
for all controller types or automatically via vGATE for mobile chan-
nels.
[<port>]Block Port
The <port> has been blocked. This can occur via remote access for
all controller types or automatically via vGATE for mobile channels.
[<port>]Restart Port
The <port> has been blocked. This can occur via remote access for
all controller types or automatically via vGATE for mobile channels.
Ethernet Interface
[99d]ERR: emac<num><state>
The Ethernet controller’s status is checked every minute and any
change in status is noted.
<num> Number of the EMAC interface (0 or 1).
<state> up Ethernet link is active
down Ethernet link is inactive
Table 7.1 Event Log Messages (continued)
Message NMS Definition
To Next Page
Loading...
