AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page200of233
<nom> - network operation mode
1
2
3
<rac> - routing area code
0..255 -
<spgc> - SPLIT_PG_CYCLE support
..0 - SPLIT_PG_CYCLE is not supported on CCCH on this cell
..1 - SPLIT_PG_CYCLE is supported on CCCH on this cell
<pat> - priority access threshold
0 -
3..6 -
<nco> - network control order
0..2 -
<t3168> - timer 3168
<t3192> - timer 3192
<drxmax> - discontinuous reception max time (in seconds)
<ctrlAck> - packed control ack
<bsCVmax> - blocked sequenc countdown max value
<alpha> - alpha parameter for power control
<pcMeasCh> - type of channel which shall be used for downlink measurements for
power control
0 - BCCH
1 - PDCH
(For non BCCH-Carrier)
arfcn: <arfcn> rxLev: <rxLev>
where:
<arfcn>
- decimal number; it is the RF channel
<rxLev> - decimal number; it is the receiption level (in dBm)
In 3G
uarfcn: <uarfcn> rxLev: <rxLev> mcc: <mcc> mnc: <mnc> scr code:
<scrcode> cellId: <cellId> lac: <lac> cellStatus: <cellStatus>
<CR><LF><CR><LF><CR><LF>
where:
<uarfcn>
- The carrier frequency is designated by the UTRA Absolute Radio
Frequency Channel Number.
<rxLev> - decimal number; it is the receiption level (in dBm).
<mcc> - hexadecimal 3-digits number; it is the mobile country code.
<mnc> - hexadecimal 2-digits number; it is the mobile network code.
<scrcode> - decimal number; it is the scrambling code
<cellId> - cell identifier; if #CSURVF last setting is 0, <cellId> is a decimal
number, else it is a 4-digits hexadecimal number.
To Next Page
Loading...
Need help?
General
