AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14
ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved page36of233
D – Dial
Parameter:
<nr> - internal phonebook position to be called
ATD<number>I[;]
ATD<number>i[;]
Issues a call overwriting the CLIR supplementary service subscription default value
for this call
If “
;” is present a voice call is performed.
I - invocation, restrict CLI presentation
i - suppression, allow CLI presentation
ATD<number>G[;]
ATD<number>g[;]
Issues a call checking the CUG supplementary service information for the current
call. Refer to
+CCUG command.
If “
;” is present a voice call is performed.
ATD*<gprs_sc>
[*<addr>]
[*[<L2P>]
[*[<cid>]]]]#
This command is specific of GPRS functionality and causes the MT to perform
whatever actions are necessary to establish communication between the
TE and the
external PDN.
Parameters:
<gprs_sc> - GPRS Service Code, a digit string (value 99) which identifies a request
to use the GPRS
<addr> - string that identifies the called party in the address space applicable to the
PDP.
<L2P> - a string which indicates the layer 2 protocol to be used (see +CGDATA
command). For communications software that does not support
arbitrary characters in the dial string, the following numeric equivalents
shall be used:
1 - PPP
<cid> - a digit which specifies a particular PDP context definition (see
+CGDCONT command).
Example
To dial a number in SIM phonebook entry 6:
ATD>SM6
OK
To have a voice call to the 6-th entry of active phonebook:
ATD>6;
OK
To call the entry with alphanumeric field “Name”:
ATD>”Name”;
OK
Reference V25ter.
To Next Page
Loading...
Need help?
General
