Tables 458
1. Use D and C to highlight the value or setting to change.
2. Specify the new value or setting.
Note: To cancel a menu or exit the dialog box without saving any changes, press
N instead of ¸.
3. After changing all applicable values or settings, press ¸ to save your changes
and close the dialog box.
From the Home Screen or a Program
From the Home Screen or a ProgramFrom the Home Screen or a Program
From the Home Screen or a Program
You can set up a table’s parameters from the Home screen or a program. You can:
• Store values directly to the system variables
tblStart and @tbl. Refer to “Storing and
Recalling Variable Values” in Operating the Calculator.
To change: Do this:
tblStart
or
@tbl
Type the new value. The existing value is
erased when you start to type.
— or —
Press A or B to remove the highlighting.
Then edit the existing value.
Graph < - > Table
or
Independent
Press A or B to display a menu of valid
settings. Then either:
• Move the cursor to highlight the setting and
press
¸.
— or —
• Press the number for that setting.
To Next Page
Loading...
Need help?
General
