Texas Instruments Voyage 200 - Starting a New Program from the Program Editor; Opening a Previous Program

Programming 578
Starting a New Program from the Program Editor
Starting a New Program from the Program EditorStarting a New Program from the Program Editor
Starting a New Program from the Program Editor
To leave the current program or function and start a new one:
Opening a Previous Program
Opening a Previous ProgramOpening a Previous Program
Opening a Previous Program
You can open a previously created program or function at any time.
1. From within the
Program Editor, press ƒ and select 1:Open.
– or –
From another application, launch Program Editor again and select
2:Open.
Note: By default, Variable shows the first existing program or function in alphabetical
order.
1. Press ƒ and select
3:New.
2. Specify the type, folder, and variable for
the new program or function.
3. Press ¸ twice.
2. Select the applicable type, folder, and
variable.
3. Press ¸.