Texas Instruments Voyage 200 - Canceling a Transmission; Common Error and Notification Messages

Connectivity 721
Canceling a Transmission
Canceling a TransmissionCanceling a Transmission
Canceling a Transmission
From either the sending or receiving unit:
Common Error and Notification Messages
Common Error and Notification MessagesCommon Error and Notification Messages
Common Error and Notification Messages
1. Press ´.
An error message is displayed.
2. Press N or ¸.
Shown on: Message and Description:
Sending unit
This is displayed after several seconds if:
• A cable is not attached to the sending unit’s link port.
– or –
• A receiving unit is not attached to the other end of
the cable.
– or –
• The receiving unit is not set up to receive.
Press N or ¸ to cancel the transmission.
Note: The sending unit may not always display this
message. Instead, it may remain BUSY until you
cancel the transmission.