Texas Instruments Voyage 200 - Connectivity; Connecting Two Units; Connecting before Sending or Receiving; Two Voyage 200 Calculators Linked Together

Connectivity 715
Connectivity
ConnectivityConnectivity
Connectivity
Connecting Two Units
Connecting Two UnitsConnecting Two Units
Connecting Two Units
The Voyage™ 200 Graphing Calculator comes with a cable that lets you connect two
units. Once connected, you can transmit information between two units. An I/O
unit-to-unit cable is included with the Voyage™ 200; use the calculator’s I/O port with
this cable.
Connecting before Sending or Receiving
Connecting before Sending or ReceivingConnecting before Sending or Receiving
Connecting before Sending or Receiving
Using firm pressure, insert one end of the cable into the link port of each unit. Either unit
can send or receive, depending on how you set them up from the
VAR-LINK screen.
You can link a TI-89 Titanium or Voyage™ 200 to another TI-89 Titanium, Voyage™ 200,
TI-89, or TI-92 Plus.
Two Voyage™ 200 calculators linked together
voyage 200 voyage 200
I/O Port
I/O Port
I/O unit-to-unit cable