Text Editor 662
Executing a Command
Executing a CommandExecuting a Command
Executing a Command
To execute a command, you must first mark the line with a
C. If you execute a line that is
not marked with
C, it will be ignored.
1. Place the cursor anywhere on the command line.
2. Press †.
The command is copied to the entry line on the Home screen and executed. The Home
screen is displayed temporarily during execution, and then the Text Editor is redisplayed.
After execution, the cursor moves to the next line in the script so that you can continue to
execute a series of commands.
Note: To examine the result on the Home screen, use a split screen or press
H¹"
Splitting the Text Editor/ Home Screen
Splitting the Text Editor/ Home ScreenSplitting the Text Editor/ Home Screen
Splitting the Text Editor/ Home Screen
With a split screen, you can view your command script and see the result of an executed
command at the same time.
To: Press:
Split the screen
… and select
1:Script view.
Return to a full screen
Text Editor
… and select
2:Clear split.
To Next Page
Loading...
