Textron Jacobsen InCommand PGM 22 - Page 149

ACCESSORIES
4157082 First Edition 10-21
10
Assembly Notes
• Install new gasket (28).
• Apply lithium grease NLGI Grade 2 to stud (63)
during assembly.
• Apply lithium grease NLGI Grade 2 to grease fitting
(19) after assembly.
• Torque hex head screw (47) to 20 lb-ft (27 N•m).
1 1/4” Lock Washer 33 5/16” Lock Nut
2 1/4-20 x 2” Hex Head Screw 34 14-20 x 3/4” Socket Head Screw
3 3/8-24 x 1/2” Hex Head Screw 35 Right-Side Roller Bracket
4 3/8” Lock Washer 36 Right-Side Mower Bracket
5 3/8” Flat Washer 37 Special Washer
6 Clutch Control Plate 38 3/8” Lock Washer
7 3/8-24 x 1” Hex Head Screw 39 3/8-16 x 1” Hex Head Screw
8 3/8” Lock Washer 40 Spacer
9 Spacer Knob 41 1/4-20 x 5/8” Socket Head Screw
10 Washer 42 Snap Ring
11 Spring 43 Bearing
12 Drive Hub 44 15-Groove Pulley
13 Hub 45 Eccentric Adjuster Nut
14 3/16 x 1-1/4” Roll Pin 46 3/8” Lock Washer
15 16-Groove Pulley 47 3/8-16 x 1-1/2” Hex Head Screw
16 Bearing 48 1/4-20 x 1/4” Set Screw
17 Snap Ring 49 10-Groove Pulley
18 5/32 x 3/4” Groove Pin 50 Belt
19 1/8” Grease Fitting 51 1/4” Flat Washer
20 Height Adjustment Nut 52 1/4” Lock Nut
21 5/16” Hex Nut 53 Belt Cover
22 5/16” Lock Washer 54 1/4” Lock Nut
23 Strap 55 1/4” Lock Washer
24 3/32 x 1-3/4” Cotter Pin 56 5/16-18 x 2-1/4” Hex Head Screw
25 3/16 x 1” Roll Pin 57 Adjustment Bracket Pivot
26 Shaft 58 Height Adjustment Bracket
27 Spacer 59 Spacer
28 Gasket 60 5/16” Lock Nut
29 Hub 61 Spacer
30 Hub Seal 62 Adjustment Bracket Pivot
31 1/4” Lock Washer 63 Stud
32 1/4-20 x 3/4” Socket Head Screw 64 Roller Adjustment Knob