Tiesse Imola LX 5200 User Manual

VLAN and SWITCH
USER GUIDE
131
root@Imola > show switch vlan
02.1Q VLans - VLan Table:
DBNum:0, VID:100
eth0:Port is not a member of this VLan.
eth1:Port is a member of this VLan. Frames egress Tagged
eth2:Port is not a member of this VLan.
eth3:Port is not a member of this VLan.
cpuPort:Port is a member of this VLan. Frames egress Tagged
In order to display the counters and statistics of a port, the following command is used:
show switch port N counters
where port-list is a list of ports separated by a space.
root@Imola > show switch port 1 counters
Getting counters for port 1.
InUnicasts 00000000 InBroadcasts 00000000
InPause 00000000 InMulticasts 00000000
InFCSErr 00000000 AlignErr 00000000
InGoodOctets 00000000 InBadOctets 00000000
Undersize 00000000 Fragments 00000000
In64Octets 00000000 In127Octets 00000000
In255Octets 00000000 In511Octets 00000000
In1023Octets 00000000 InMaxOctets 00000000
Jabber 00000000 Oversize 00000000
InDiscards 00000000 Filtered 00000000
OutUnicasts 00000000 OutBroadcasts 00000000
OutPause 00000000 OutMulticasts 00000000
OutFCSErr 00000000 OutGoodOctets 00000000
Out64Octets 00000000 Out127Octets 00000000
Out255Octets 00000000 Out511Octets 00000000
Out1023Octets 00000000 OutMaxOctets 00000000
Collisions 00000000 Late 00000000
Excessive 00000000 Multiple 00000000
Single 00000000 Deferred 00000000
OutDiscards 00000000
Other possible actions are:
show switch port N diagnostic
in order to display the port status and:
show switch port N vlan
in order to display the VLAN to which it belongs.
In order to reset all the counters of a port or all the ports, the following command is used:
clear_counter switch port [<port-list>]
where port-list is a list of ports, separated by spaces.
The command detect-link-state applied to a VLAN puts down the VLAN if the ports to which it
refers to are down.

Tiesse Imola LX 5200 Specifications

General

Brand	Tiesse
Model	Imola LX 5200
Category	Network Router
Language	English