root@Imola> show log full
Jan 1 00:01:04 localhost syslogd 1.4.1: restart.
Jan 1 00:01:06 localhost kernel: Memory: 59672KB available (1688K code, 357K da
ta, 240K init)
Jan 1 00:01:06 localhost kernel: number of JEDEC chips: 1
Jan 1 00:01:06 localhost kernel: cfi_cmdset_0002: Disabling erase-suspend-progr
am due to code brokenness.
Jan 1 00:01:06 localhost kernel: Imola3 flash_0: Using Static image partition definition
Jan 1 00:01:06 localhost kernel: Creating 2 MTD partitions on "Imola3:0":
Jan 1 00:01:06 localhost kernel: 0x00000000-0x00070000 : "U-boot"
Jan 1 00:01:06 localhost kernel: 0x00070000-0x00080000 : "environment"
Jan 1 00:01:06 localhost kernel: imola3_init: mach-type=604
Jan 1 00:01:06 localhost kernel: 3 cmdlinepart partitions found on MTD device i
mola3-nand
Jan 1 00:01:06 localhost kernel: Creating 3 MTD partitions on "imola3-nand":
Jan 1 00:01:06 localhost kernel: 0x00000000-0x00100000 : "kernel"
Jan 1 00:01:06 localhost kernel: 0x00100000-0x00400000 : "initrd"
Jan 1 00:01:06 localhost kernel: 0x00400000-0x01000000 : "user"
Jan 1 00:01:06 localhost kernel: RAMDISK: Compressed image found at block 0
Jan 1 00:01:06 localhost kernel: ISDN subsystem Rev: 1.1.4.1/1.1.4.1/1.1.4.1/1.
1.4.1/none/1.1.4.1 loaded
Jan 1 00:01:07 localhost ipppd[1696]: Found 1 device: /dev/ippp0
--More-- (70% of 1846 bytes)
It is possible to transmit the content of the log file on a TFTP server through the command:
upload log-file to <tftp-server>
After the transmission on the server the file will be called Imola.log
The commands:
set alarm host <ip-address>
set alarm facility <facility>
set alarm priority <priority>
set alarm on
send different alarm signals sent by the router towards the specified host. Alarms are sent through
Syslog.
In order to specify the IP source address with which messages must be sent to TFPT server, the
command is:
set tft source <local-ip> or set tftp source loopback
in order to use the loopback address.
To Next Page
Loading...
Need help?
General
