is used to configure a default route on the dialer ippp1. This route will be activated only in case of
automatic dialling (set ISDN dialer ippp1 dialmode auto) or when a call is established.
How to verify the configuration of an activated dialer:
root@Imola> show interface isdn dialer ippp1
Current setup of interface 'ippp1':
EAZ/MSN: 999
Phone number(s):
Outgoing: 0125629552
Incoming:
Dial mode: manual
Secure: off
Callback: off
Reject before Callback: off
Callback-delay: 5
Dialmax: 1
Hangup-Timeout: 60
Incoming-Hangup: on
ChargeHangup: off
Charge-Units: 0
Charge-Interval: 0
Layer-2-Protocol: hdlc
Layer-3-Protocol: trans
Encapsulation: syncppp
Login: pppuser
Accept Remote IP: yes
Set Local IP: no
Default Route: no
Masquerade: no
---------------------------------------
ippp1 is not connected
9: ippp1: <POINTOPOINT,NOARP,UP> mtu 1500 qdisc pfifo_fast qlen 30
link/ppp
RX: bytes packets errors dropped overrun mcast
0 0 0 0 0 0
TX: bytes packets errors dropped carrier collsns
0 0 0 0 0 0
It is also possible to use both ISDN channels on a single logical connection (multilink connection). In
order to enable the multilink connection the following commands can be used:
set isdn dialer ippp1 multi-link
The second channel, called slave, must be activated when the master channel connection is
activated. The following command is used for this operation:
set trigger isdn up isdnctrl addlink ippp1
The slave channel will be automatically disconnected when the master channel is disconnected.
When the master channel is activated it is possible to verify the activation of the two channels:
root@Imola> isdnctrl list ippp1
Current setup of interface 'ippp1':
To Next Page
Loading...
Need help?
General
