47
13. COORDINATE MEASUREMENT
2. Enter search criteria.
Enter following items.
(1) Coordinate point name
(2) Search condition (complete match)
(3) Search direction
3. Press [OK] to display the details of searched data.
Searching the coordinate point name
Data is saved according to the time it was recorded. When there is more than one coordinate point name
matching the search, "the point nearest to the currently selected data" is selected. See the Note below for
search method options.
• Options for the setting items are as follows. (* is the setting when the power is turned to ON.)
* Search method: (searches backward from the current point name) */
(searches forward from the current point name)
PROCEDURE Coordinate Data Search (Partial match)
1. Press [Search] in the registered coordinate data list screen.
All coordinate data that includes characters and numbers
entered in step 2 is displayed.
2. Enter search criteria.
Enter the following items.
(1) Partial coordinate point name
(2) Search condition (partial match)
3. Press [OK] to display data that matches the search
information.
4. Select the data and press {ENT} to display the details.
13.1.1 Setting Azimuth Angle from Backsight Coordinates
Set the azimuth angle of the backsight station by calculating by the coordinates.
PROCEDURE
1. Enter the instrument station data.
"13.1 Entering Instrument Station Data and Azimuth
Angle"
To Next Page
Loading...
Need help?
General
