5. SYSTEM MODE EO18-33031
5.4 DIAGNOSTIC
5-22
5.4.2 AUTO DIAGNOSTICS
The procedure for printing the self-diagnosis result is mostly the same as that for the maintenance
counter/parameter setting data described in Section 5.4.1 MAINTENANCE COUNTER.
The following table shows the menu structure from top menu of the system mode to AUTO DIAGNOSTIC.
The menu structure of AUTO DIAGNOSTIC
Menu item
<1>DIAGNOSTIC
AUTO DIAGNOSTIC
THERMAL TRANSFER
NO
YES
DIRECT THERMAL
NO
YES
DISPLAY
NOTE:
When an error occurs while printing, the error message is displayed, the ERROR LED turns on, and the
ONLINE LED turns off. Though the error can be cleared by pressing the [ENTER], [CANCEL] or [MODE] key,
the printer does not reprint the label automatically.
To Next Page
Loading...
