Toshiba B-EX6 Series - 10.10 LCD Messages and LED Indications

10. ON LINE MODE EM18-33031
10.10 LCD MESSAGES AND LED INCATIONS
10-23
10.10 LCD MESSAGES AND LED INDICATIONS
No
LCD Message
2
nd
line
(English)
LED
indications
Printer status
Restoration by
the [RESTART]
key
Yes/No
Acceptance of
Status Request
and Reset
Command
Yes/No
ON
LINE
ERROR
1 ONLINE

● In the online mode --- Yes

●
In the online mode
(Communicating)
--- Yes
 
In the online mode with a ribbon
near end detected
(Note 1)
--- Yes
2 HEAD OPEN
● ●
A feed or an issue was attempted
with the head opened.
--- Yes
●

A feed or an issue was attempted
with the head opened in a ribbon
near end state.
(Note 1)
--- Yes
3 PAUSE
● ●
In a pause state
Yes Yes
●

In a pause state with a ribbon near
end detected
(Note 3)
Yes Yes
4 COMMS ERROR ●

A parity error or framing error has
occurred during communication by
RS-232C.
Yes Yes
5 PAPER JAM ●

▪ A paper jam occurred during
paper feed.
▪ The media is not set properly.
▪ The media actually used and the
selected media sensor type do not
match.
▪ The media sensor position does
not align with the black mark
position.
▪ The actual media size and the
specified media length do not
match.
▪ The media sensor level is not
suitable for the actual media.
▪ The gap of pre-printed label
cannot be detected.
Yes Yes
6 CUTTER ERROR ●

▪ A paper jam occurred in the
cutter.
▪ The cutter did not move from the
home position.
▪ The cutter cover was open.
Yes Yes
7 NO PAPER ●

▪ The media has run out.
▪ The media has not been set.
▪ Media sensor level is not suitable
for the paper used.
Yes Yes
8 NO RIBBON ●

The ribbon has run out. Yes Yes
9 HEAD OPEN ●

A feed or an issue was attempted
with the head opened.
(Except media feed caused by the
[FEED] key or Expansion I/O)
Yes Yes
10 HEAD ERROR ●

▪ A broken dot error has occurred in
the thermal head.
▪ The error has occurred in the
head driver.
Yes Yes